DENSITY OF THE ADHERENCE OF RESTORATIVE MATERIAL TO THE ENAMEL OF TEETH WITH DIFFERENT FORMATION OF CARIOUS CAVITY EDGE

  • Yu. V. Smeyanov Sumy State University, 2, Rymskogo-Korsakova st., 40007 Sumy, Ukraine
  • Yu. V. Lakhtyn Sumy State University, 2, Rymskogo-Korsakova st., 40007 Sumy, Ukraine
  • A. M. Romanyuk Sumy State University, 2, Rymskogo-Korsakova st., 40007 Sumy, Ukraine
  • O. V. Belonozhko Sumy State University, 2, Rymskogo-Korsakova st., 40007 Sumy, Ukraine
Keywords: carious cavity class I, preparation of carious cavity, restoration of carious cavity, density of the adherence of material to enamel, scanning electron microscopy

Abstract

Introduction. At present, the question of the influence of carious cavity edge design on the density of the adherence of restorative material to the enamel remains discursive; there is some confusion in the open access publications on this topic.

Objectives. To study the density of the adherence of restorative material to the enamel of teeth depending on the design of the formation of carious cavity edge.

Materials and methods. The research was carried out using 30 intact third molars extracted upon clinical indications. The samples were divided into three groups, 10 in each, depending on the formation of carious cavities of the 1st class according to Black classification. In group I a classical carious cavity with even, straight-edged walls without the formation of the bevel (folds) of the enamel was formed. In group II, the outer beveling of enamel was made at an angle of 45º to the enamel-dentine border. In group III, the cavity was formed with an internal beveling of enamel. Carious cavities were restored with micro-hybrid composite light cured material LATELUX (PE "LATUS", Kharkiv). One-time vertical mechanical load with a force of 98.07 N was performed on restoration, and treated with thermocycled in a mode of 200 cycles at a temperature from 5 °C to 55 °C with an exposure of 60 seconds at each temperature. The teeth were separated in a medio-distal direction through a center of restoration with diamond disks, placed in a column of a raster electron microscope with a low vacuum chamber REM 102, and the contact area of the restoration with solid tissues of the teeth was studied, the density of their adherence, and the present gaps were measured and expressed in micrometers (μm)

Results. Electron diffraction pattern of the samples of group I showed that the density of the adherence of the restorative material to the enamel of the carious cavity was different throughout: sometimes thick, sometimes the space in the contact area was determined. Moreover, the space was formed between the adhesive layer of the material and enamel. The space size averaged 7.90 ± 0.73 μm (95% CI: 6.3: 9.5). Enamel prisms adjoined in the area of contact with the material partly linear, longitudinal along its axis or transversely, obliquely with a slanted body.

In the samples of group II restorative material was evenly in contact with the layer of adhesive, adherence of which to the enamel edge of the carious cavity was dense almost throughout. But in some areas there was a violation of the contact of the enamel with the adhesive layer, there were cracks 2.76 ± 0.52 μm (95% CI: 1.6: 3.9). Enamel prisms in the area of contact with the material were located more transversely to their axis, obliquely with a slanted body.

In the samples of group III, the adherence of the restorative material to the enamel of the carious cavity was not dense almost throughout. The restorative material had a uniform contact with the adhesive. At the same time, there was a breach of contact in the form of cracks of 16.50 ± 0.89 (95% CI: 14.6: 18.4) μm observed between adhesive and enamel. Enamel prisms in the zone of contact with the material were linear, longitudinal along its axis.

Conclusions. The greatest density of the adherence of restorative material to the enamel of teeth occurs when forming the outer beveling of the enamel edge in the carious cavities of the 1st class according to Black classification.

Downloads

Download data is not yet available.

References

1. Al Sunbul H, Silikas N, Watts DC. Polymerization shrinkage kinetics and shrinkage-stress in dental resin-composites. Dental Materials. 2016;32(8):998-1006. DOI: https://doi.org/10.1016/j.dental.2016.05.006.
2. Alvanforoush N, Palamara J, Wong RH, Burrow MF. Comparison between published clinical success of direct resin composite restorations in vital posterior teeth in 1995–2005 and 2006–2016 periods. Australian dental journal. 2017;62(2): 132-145.
3. An B, Wang R, Arola D, Zhang D. Damage mechanisms in uniaxial compression of single enamel rods. Journal of the Mechanical Behavior of Biomedical Materials. 2015;42:1-9.
4. Benetti AR, Peutzfeldt A, Lussi A, Flury S. Resin composites: Modulus of elasticity and marginal quality. Journal of dentistry. 2014;42(9):1185-1192. DOI: https://doi.org/10.1016/j.jdent.2014.07.004.
5. Braga RR, Koplin C, Yamamoto T, Tyler K, Ferracane JL, Swain MV. Composite polymerization stress as a function of specimen configuration assessed by crack analysis and finite element analysis. Dental Materials. 2013;29(10):1026-1033. DOI: https://doi.org/10.1016/j.dental.2013.07.012.
6. Carvalho RM, Santiago SL, Fernandas CAO, Suh BI, Pashley DH. Effects of prism orientation on tensile strength of enamel. Journal of Adhesive Dentistry. 2000;2(4):251-257.
7. Coelho-de-Souza FH, Rocha Ada C, Rubini A, Klein-Júnior CA, Demarco FF. Influence of adhesive system and bevel preparation on fracture strength of teeth restored with composite resin. Braz Dent J. 2010;21:327-331. DOI: http://dx.doi.org/10.1590/S0103-64402010000400007.
8. Ferracane JL, Hilton TJ. Polymerization stress–Is it clinically meaningful? Dental Materials, 2016;32(1):1-10. DOI: https://doi.org/10.1016/j.dental.2015.06.020
9. Isenberg BP, Leinfelder KF. Efficacy of beveling posterior composite resin preparations. J Esthet Dent. 1990; 2:70–73. DOI: 10.1111/j.1708-8240.1990.tb00612.x.
10. Kuper NK, van de Sande FH, Opdam NJM. [et al.]. Restoration Materials and Secondary Caries Using an In Vitro Biofilm Model. JDR. 2015;94(1):62-68.
11. Lakhtin YV, Smeyanov YV. Modeling the stress state of hard tissues of a tooth in the process of restoration of class I carious cavities. GISAP: Medical Science, Pharmacology. 2016;9:17-20.
12. Laske M, Opdam NJ, Bronkhorst EM, Braspenning JC, Huysmans MCD. Longevity of direct restorations in Dutch dental practices. Descriptive study out of a practice based research network. Journal of dentistry. 2016;46:12-17.
13. Lynch CD, O'Sullivan VR, Dockery P, McGillycuddy CT, Sloan AJ. Hunter-schreger band patterns in human tooth enamel. J Anat. 2010;217(2):106-15.
14. Lynch CD, Wilson NHF.Managing the phase-down of amalgam: part I. Educational and training issues. British Dental Journal. 2013;215(3):109-113. doi:10.1038/sj.bdj.2013.737.
15. Peutzfeldt A, Asmussen E. Determinants of in vitro gap formation of resin composites. J. Dent. 2004;32 (2):109–115.
16. Sabbagh J, McConnell RJ, McConnell MC. Posterior composites: Update on cavities and filling techniques. Journal of dentistry. 2017;57:86-90. DOI: https://doi.org/10.1016/j.jdent.2016.11.010.
17. Smeyanov Y, Lakhtin Y. The influence of stress-strain processes in tooth enamel on the marginal permeability of class i restorations with a different design of the edge of the carious cavity. Wiadomości Lekarskie. 2018; LXXI(1):135-139.
18. Staxrud F, Tveit AB, Rukke HV, Kopperud SE. Repair of defective composite restorations. A questionnaire study among dentists in the Public Dental Service in Norway. Journal of dentistry. 2016;52:50-54. DOI: https://doi.org/10.1016/j.jdent.2016.07.004.
19. Umer F, Naz F, Khan FR. An in vitro evaluation of microleakage in class V preparations restored with Hybrid versus Silorane composites. J Conserv Dent. 2011;14:103-107. doi: 10.4103/0972-0707.82600.
20. Yoon YJ, Kim IН, Han SY. The reason why a sheath exists in enamel. International Journal of Precision Engineering and Manufacturing. 2015;16(4):807-811.
Published
2019-03-29
How to Cite
1.
Smeyanov YV, Lakhtyn YV, Romanyuk AM, Belonozhko OV. DENSITY OF THE ADHERENCE OF RESTORATIVE MATERIAL TO THE ENAMEL OF TEETH WITH DIFFERENT FORMATION OF CARIOUS CAVITY EDGE. East Ukr Med J [Internet]. 2019Mar.29 [cited 2024Mar.28];7(1):20-7. Available from: https://eumj.med.sumdu.edu.ua/index.php/journal/article/view/5